2711P-RN15S Allen-Bradley PLC Hardware

Brand：Allen-Bradley Model number：2711P-RN15S

Country of origin: United States Product weight：0.1kg

Product Details：

Solid-state equipment has operational characteristics differing from those of electromechanical equipment. Safety Guidelines for the Application, Installation and Maintenance of Solid State Controls (Publication SGI-1.1 available from your local Rockwell Automation sales office or online at http://www.rockwellautomation.com/literature/) describes some important differences between solid-state equipment and hard-wired electromechanical devices. Because of this difference, and also because of the wide variety of uses for solid-state equipment, all persons responsible for applying this equipment must satisfy themselves that each intended application of this equipment is acceptable.

Follow these steps to install a new communication module.

Disconnect power from the terminal.

2. If the display module is removed from the panel, set the terminal, display side down, on a clean, flat, stable surface

3. Position the communication module over the logic module so that the connector on the bottom of the communication module aligns with the connector on the logic module.

4. To prevent ESD between the modules, allow the communication module to touch the logic module before making the connection.

5. Push down on the communication module until the connectors are seated.

6. Tighten the four screws that secure the communication module to the logic module to a torque of 0.58 N•m (5…7 lb•in).

We have the same series of models in stock. If you don't find the model you need, please contact us and we will provide you with an official quotation！

Allen-Bradley 440G-TZS21UPRH

Allen-Bradley 700-HLS1U2

Allen-Bradley 1440-SDM02-01RA

Allen-Bradley 1492-IFM40F-3

Allen-Bradley 1746-A10

Allen-Bradley 1746-NI4

Allen-Bradley 1746-NI8

Allen-Bradley 1747-L541

Allen-Bradley 1747-L552

Allen-Bradley 1756-A4

Allen-Bradley 1756-A10

Allen-Bradley 1756-A13